%% Package `pst-light3d.tex' %% This version of pst-light3d needs the xkeyval package. Get it from CTAN if it is not part of your local TeX installation. Save the files pst-light3d.sty TEXMF/tex/latex/pstricks/ pst-light3d.tex TEXMF/tex/generic/pstricks/ pst-light3d.pro TEXMF/dvips/pstricks/ in any place, where latex or any other TeX program will find it. If you like to get the documentation file in another format run latex pst-light3d-doc latex pst-light3d-doc dvips pst-light3d-doc to get a PostScript file. But pay attention, that the pst-light3d files are saved in the above mentioned way, before you run latex on the documentation file. The intermediate DVI file works only with viewers which can interprete the embedded PostScript code. For another PDF output read the Introduction from the documentation. hv, 2004-09-29